Verified Document

OSHA Electrical Safety Occupational Safety Term Paper

Hence this will help in safeguarding utility line workers from possible electrocution. The generators need to be turn off and allow them to cool prior to refuelling. (Occupation Safety and Health Administration, n. d.) (ii) Power lines: Safety measure are required to be adopted from overhead and underground power lines as they carry very high voltage current. Fatal electrocution is the main impending risk as also burns and falls. The safety precautions that are required to be taken are (a) Overhead and underground power line indicators need to be looked. (b) it is important that one stays 10 feet at the minimum from overhead power lines and take for granted that they are energised. (c) Lines need to be de-energised and grounded when people are working in close proximity. (d) While working near power lines, use of non-conductive wood or fibreglass ladders need to be used. (Occupation Safety and Health Administration, n. d.)

(iii) Extension Cords: Wear and tear from routine uses can render the cords to be loose and expose them. Cords which are not of 3-wire types and are not suitable for rigorous use, or which have been modified raise the risk of contacting electrical current. It is important to adhere to the following (a) Use of equipment which has received the approval of aligning with OSHA norms. (b) Cords should not be altered or used them in an incorrect manner (c) Cords that are factory assembled must only be used as also extension cords that are 3-wire type. (d) Cords, connection devices and fitting which are capable of strain relief should be used only. (e) Care must be taken to remove receptacles by pulling on the plugs & not the cords. (Occupation Safety and Health Administration, n. d.)

(iv) Equipment: Because of the rough nature of construction work, routine use of electrical equipment renders normal wear and tear. This causes drop-outs in insulation, short-circuits, and also results in exposed wires. Absence of ground-fault protection can trigger a ground fault transmitting current through the body of the worker. The following safety precautions need to be undertaken (a) Use of Ground-Fault Circuit Interrupters -- GCFI in every 120-volt, single-phase, 15 and 20 ampere receptacles. Alternative using Assured Equipment Grounding Conductor Program -- AEGCP will also be beneficial. (b) Use of two-core insulated tools and equipment which are distinctively marked (c) it is important to have a visual inspection of all electrical equipment prior to use and looking for any equipment...

(Occupation Safety and Health Administration, n. d.)
(v) Electrical accidents: In cases where the power supply to the electrical equipment has not been grounded, or the path has been dropped out, fault current might pass across the worker's body giving electrical burns or loss of life. Even if the power system is adequately grounded, electrical equipment can immediately alter from safe to hazardous due to extreme conditions and improper handling. The following safety measures need to be adopted (a) Undertaking of a visual inspection before use and remove any defective equipment from being used (b) it is important to ensure that all power systems, electrical circuits and electrical equipments are grounded. (c) Regular inspection of electrical systems to assure that the path to the ground is continuous. (d) Ground prongs should not be removed from cord and plug connected apparatus as also extension cords. (e) Use of double-insulated tools is important and every exposed metal parts of equipment need to be grounded. (f) Avoiding standing in damp and moist regions while using portable electrical power tools. (Occupation Safety and Health Administration, n. d.)

References

American Pipeline Contractors Association. (n. d.) "Tool Box Safety Topic"

Retrieved 28 April, 2012 from http://www.americanpipeline.org/ToolBox/English/ElectricalSafety.pdf

Chao, Elaine L; Henshaw, John L. (2002) "Controlling Electrical Hazards"- OSHA"

Retrieved 28 April, 2012 from http://www.osha.gov/Publications/osha3075.pdf

Electricity Forum. (2012) "OSHA Electricity Safety" Retrieved 28 April, 2012 from http://www.electricityforum.com/forums/osha-electrical-safety.html

Occupation Safety and Health Administration. "(n. d.) OSHA Fact Sheet."

Retrieved 28 April, 2012 from http://www.osha.gov/OshDoc/data_Hurricane_Facts/elect_safety.pdf

United States Department of Labor. (2012) "OSHA Fact Sheet: Working Safely with Electricity" Retrieved 28 April, 2012 from http://www.osha.gov/SLTC/electrical/index.html

United States Department of Labor. (2012) "U.S. Department of Labor Assistant Secretary for Occupational Safety and Health Washington D.C. 20210 OSHA Instruction STD1-16.7 Jul 1, 1991 Directorate of Compliance Programs"

Retrieved 28 April, 2012 from http://www.osha.gov/pls/oshaweb/owadisp.show_document-p_table=DIRECTIVES&p_id=1750

Sources used in this document:
References

American Pipeline Contractors Association. (n. d.) "Tool Box Safety Topic"

Retrieved 28 April, 2012 from http://www.americanpipeline.org/ToolBox/English/ElectricalSafety.pdf

Chao, Elaine L; Henshaw, John L. (2002) "Controlling Electrical Hazards"- OSHA"

Retrieved 28 April, 2012 from http://www.osha.gov/Publications/osha3075.pdf
Electricity Forum. (2012) "OSHA Electricity Safety" Retrieved 28 April, 2012 from http://www.electricityforum.com/forums/osha-electrical-safety.html
Retrieved 28 April, 2012 from http://www.osha.gov/OshDoc/data_Hurricane_Facts/elect_safety.pdf
United States Department of Labor. (2012) "OSHA Fact Sheet: Working Safely with Electricity" Retrieved 28 April, 2012 from http://www.osha.gov/SLTC/electrical/index.html
Retrieved 28 April, 2012 from http://www.osha.gov/pls/oshaweb/owadisp.show_document-p_table=DIRECTIVES&p_id=1750
Cite this Document:
Copy Bibliography Citation

Related Documents

OSHA Standards for Industrial Hazards Prevention and Control
Words: 1161 Length: 4 Document Type: Case Study

OSHA Safety Standards KEEPING INDUSTRIAL HAZARDS AT BAY Priority Applicable Standards These are (OSHA, 2015): Eye and Face Protection 1910.133 -- the employer is obliged to provide employees with suitable protection for eyes and faces when they expose themselves to certain hazards. These include flying particles, melted metals, liquid chemicals, acids and other acidic liquids, chemical gases or fumes, and possible damaging light radiation. Detachable side protectors shall be provided to protect them from

Safety Principles and Issues
Words: 2818 Length: 10 Document Type: Term Paper

Safety Injury Prevention in the Home Injury Prevention Workplace Motor Vehicles and Natural Disasters Safety is concerned with preventing or minimizing injuries and fatalities that result from a variety of circumstances. Injury prevention is a priority area for health promotion officials. Whether in the home or workplace, all individuals are subject to injury at some point in their lives, though certain populations have been identified as being at greater risk than others. The key

OSHA High Priority Standards Ventilation.
Words: 579 Length: 2 Document Type: Essay

The hand-held grinders used in finishing could lead to massive injuries. Four Written Programs 1910.95: Occupational noise exposure. The written program outlining the guidelines to be posted and distributed is necessary to apprise the employees not only of the laws and regulations, but also of the potential risks to their hearing. 1910.104: Oxygen. The written program for oxygen use, such as the oxy-acetylene torch, requires proper placarding and operating instructions be posted

Workplace Safety
Words: 2136 Length: 7 Document Type: Research Paper

Workplace Safety Employee health and safety management Most U.S. firms are offering disease management and health promotion programs to employees to address the increasing health care costs through improving employee lifestyle and overall health. Nevertheless, the U.S. has not been efficient in providing employees with integrated comprehensive health programs. Comprehensive programs of promoting employee health might encompass a series of strategies including supportive environments, health education, accessing support services, employee integration into

Oshe the Occupational Safety and Health Act
Words: 2037 Length: 7 Document Type: Term Paper

OSHE The Occupational Safety and Health Act of 1970 set the stage for the creation of the Occupational Safety and Health Administration (OSHA) whose duties include the prevention of illnesses, injuries, and deaths that are work-related. The administration has produced tangible results in reducing occupational deaths and injuries by 62% and 42% respectively. The reason behind OSHA's success is down to its regular inspection of work facilities, as well as issuance

Functions of Nfpa and OSHA in Fire Service
Words: 978 Length: 3 Document Type: Essay

NFPA and OSHA in Fire Service: The National Fire Protection Association is a global nonprofit organization that was founded in 1896 to lessen the burden of fire and other hazards throughout the globe. The organization seeks to enhance the quality of life through offering and supporting universal codes and standards, training, research, and education that focus on dealing with hazards. Given its membership and presence in almost 100 countries, NFPA is

Sign Up for Unlimited Study Help

Our semester plans gives you unlimited, unrestricted access to our entire library of resources —writing tools, guides, example essays, tutorials, class notes, and more.

Get Started Now