Water-flow problems such as this one described in Thailand attribute to much of arsenic flow in drinking water throughout the world. For example, flat, low-lying areas such as large plains and delta regions are more prone to high arsenic ground waters. The process of delta development also leads to high deposit levels, because the higher the delta, the less flushing is likely to have occurred.
Research Limitations and Assumptions
The limitations of studies involving arsenic levels in drinking water supplies is that the health risks associated with such levels were not identified until much later. As a result, there is little data ranging from the time period where the levels were first likely to have started to effect people. In other words, detailed studies and notes must be taken to provide a sounder basis for understanding the causes of the problem as it applies in a time frame. Other limitations include the fact that local geology and hydrogeology have not been measured to include water level monitoring, studies or mineralogy, chemical composition and adsorption behavior of aquifer materials. Either purpose built piezometers or suitable production wells should be monitored for changes in arsenic and other water quality parameters; however, such studies are expensive and are not warranted unless the scale of the problem is large. Thus, an important limitation is that unless million of people are affected, as in the case in Bangladesh, this type of monitoring may not occur.
Additional limitations include the fact that since high arsenic ground waters are found in aquifers in which the sediments have been deposited in the last ten thousand years, these deposits will be flushed away. As long as these sediments are flushed away in the normal ground water flow, it may be unknown what levels existed there or were deposited there to begin with. Thus, an important limitation is the timescale of the arsenic being deposited which is difficult if not impossible to detect, even with the proper equipment. Also, wells that are currently arsenic free does not give a guarantee that they will remain that way in the future. Other limitations include the fact that in poorer countries in which arsenic in the drinking water supply does exist, the country cannot afford to pay for this type of testing or lacks testing facilities. Significant changes in arsenic transport transportation in groundwater may occur locally due to the influence of mining, groundwater pumping and irrigation. Other limitations include the possibility that heavy pumping of deep aquifers could draw contaminated groundwater down to the aquifer, or that poor well construction may lead to the rapid movement of contaminated water. As a result, new developments must be implemented to deal with this problem before it takes years to become apparent.
New Developments
New developments must dealt with the challenging issue of identifying and mitigating existing contaminated wells. Those most badly contaminated must be addressed first, and then other water sources that have not ever been evaluated must be evaluated and tested. New developments could consist of a new method of flushing out arsenic contaminated sources, at a cost that is low enough fro poorer countries to afford. Rural communities in developing countries pose the biggest threat, which is poorly understood by these poverty stricken communities. As indicated by a review of the literature, many of the worst problems occur in poor countries that do not have the necessary infrastructure and financial means to be able to properly respond. The U.S. has many companies that manufacture household and industrial level water filters that can test the levels of arsenic and filter arsenic from drinking water supplies. Unfortunately, not all countries can afford these products, as there are other life threatening issues that they must deal with first, such as starvation.
Personal Thoughts
In the area involving contaminated water supplies, I believe that some of the information available appears to be conflicting with the available and timely solutions. Most of these conflicts rest between the U.S. And other parts of the world. For example, arsenic was noted as a significant problem contributing to health hazards in Bangladesh and West Bengal in the 1980s and early 1990s, but it does not appear that this problem is even on its way to being solved. It is now roughly about 15 to 17 years later, and the water supplies in these poorer countries are still contaminated. If the U.S. EPA offers financial assistance to local governments to assist them comply with regulations, it is assumable that the WHO could do the same, especially for poor...
Drinking Water Have you ever forgotten to water your houseplants or garden? What do you notice? When you give the plants water, what do you see happening? Likely, within a few moments, you see the plant begin to perk up, to stretch, and to look healthier. Well, our bodies are similar in that water is an essential part of our daily intake -- every cell, tissue and organ in our bodies
Seawater and Desalination The seas are made up of water, but that water is not drinkable, requiring treatment in desalination plants prior to distribution in drinking water systems. To understand how and why it is not drinkable, and the complexities of desalination, it is necessary to look at the chemical and physical properties of seawater. Following this, two different desalination methods are discussed. Chemical and Physical Properties of Sea Water Seawater is made
Water v. soda Water is the building block of life; our bodies are composed mostly of water, as is the earth on which we live. If we "are what we eat," then it makes the most sense to drink more water than any other beverage available. However, many people fall out of the habit of drinking water because of all the flavored beverages on the market. Although most beverages are based
The EPA had been developing new regulations at a pace that was deemed too slow by Congress. Only one of the interim standards set in 1975 had been updated. There were also deficiencies in the implementation. Microbial contamination had not been sufficiently addressed. By the early 1980s, synthetic chemicals were being found in drinking water with increasing frequency. The 1986 Amendment therefore addressed these issues. Maximum levels for many
Cadmium in Wastewater and Drinking Water The importance of efficiently controlling and monitoring potential toxins in water systems is extremely important. The potential contaminant known as Cadmium (Cd) is a naturally occurring trace metal that is regularly found in various types of ores. Its most common commercial uses are in the metal plating and coating of transportation vessels, household-cooking utensils, machinery and nickel-cadmium batteries (Advanced Purification Engineering Corporation, 2010). As
BPA is an acronym that stands for bisphenol A. It is an industrial chemical used in plastics for more than 50 years—plastics such as water bottles. While plastics have their utility in modern life, the danger of using them is that chemicals like BPA have a tendency to seep out of the plastics and into the food or water contained by the plastics (Bauer). This is all the more worrisome
Our semester plans gives you unlimited, unrestricted access to our entire library of resources —writing tools, guides, example essays, tutorials, class notes, and more.
Get Started Now